Home | Family
As a homeowner deciding to take on your own fence building project could be a daunting task. There are many different materials to choose from, some of them more complex than others. Using metal for your fence can be a great investment, not only are they stronger and more durable than wood they are also relatively easy to install, especially if you purchase a prefabricated metal fence. The remaining part of this article will take you through the step-by-step process of installing a metal fence. The most important step when erecting any kind of structure is the planning step. Here are some things to keep in mind when in the planning stage: 1 - Contact your local building regulations to find out about building permits, mandatory setbacks and permissible fence heights 2 - Mark off all underground utilities before you dig. This includes locating the lines for water, gas, electrical, cable television and telephone. 3 - Mark all legal boundaries to ensure your fence does not extend beyond the property line. It is actually a good idea to keep your fence four inches inside your property line just in case. 4 - Stake out your fence plan using wooden stakes and string so you can get an idea of how it will look and where the posts and gate should be. Alright, so you've got everything marked off, your layout is set up, now it is time for the longest and hardest part of building a fence, drilling the holes for the posts. 1 - It is a good idea to mark all the post locations before you set to drilling. Spray paint works well. 2 - The holes for the posts should be at least two feet deep and 8 inches wide. This will ensure that there won't be any sinking or movement after the post is set. 3 - Digging these holes by hand will be excruciating, so it is advised to rent an auger from your local hardware store. You can thank me later. That last step was really the hardest part of the whole operation, the rest here will be easy-peasy-lemon-squeezy. The holes are dug, so now it is time to set the posts. 1 - Place a mark on the post where the post should line up with the surface of the ground. This will ensure you do not set the post too deep. 2 - After you have mixed up your concrete, pour a small amount in the hole and then place the first corner post making sure it is square. Then fill the hole with the remaining concrete. 3 - Next, set the post at the other corner and once both corners are secure you can run a line that will help to ensure the remaining posts will be set squarely. 4 - Set the remaining posts, double-checking everything is square and allow the concrete to cure overnight. If you went with a prefabricated metal fence, and your posts are the appropriate length apart everything should be fairly simple from this point on. However you may end up with up with some odd spaces and will to cut a panel to size. 1 - Simply measure the distance between the two posts, taking the measurement from the inside and then subtract a half an inch. The remainder is the length to cut the panel. 2 - Before you install the panel make sure you coat the area with a zinc-rich primer, and then paint over it using a matching colour. This will ensure the area you cut will not rust.
Corey Rozon is an international freelance writer from Canada. This article about using metal pipe bending to build a metal fence was written on behalf of a fencelosangeles.com/”>Los Angeles Fence Company.
Article Source:- Link Building
Please Rate this Article
5 out of 54 out of 53 out of 52 out of 51 out of 5
Not yet Rated
